Which one of the following helps experimental confirmation of the Crystalline state of matter?

The electrical conductivity of pure semiconductor is:

Consider the following statements pertaining to the resistance of a conductor:
1. Resistance can be simply defined as the ratio of voltage across the conductor to the current through the conductor. This is, in fact, Georg Ohm’s law.
2. Resistance is a function of voltage and current.
3. Resistance is a function of conductor geometry and its conductivity
Which of the above statements are correct?

The ratio of ionic radii of Cations i.e.and that of Anions i.e.for stable and unstable ceramic crystal structure, is:

Which one of the following statements is correct?

In an extrinsic semiconductor the conductivity significantly depends upon:

In some substances when an electric field is applied the substance become polarized. The electrons and nucleii assume new geometrical positions and the mechanical dimensions are altered. This phenomenon is called:

In ferromagnetic materials, the net magnetic moment created due to magnetization by an applied field as:

At what temperatures domains lose their ferromagnetic properties?

Which of the following materials does not have paramagnetic properties?
1. Rare earth elements (with incomplete shell)
2. Transition elements
3. Magnesium oxide
Select the correct answer from the codes given below:

Which of the following regions of operation are mainly responsible for heating of the transistor under switching operation?
1. Saturation region
2. Cut-off region
3. Transition from saturation to cut-off
4. Transition from cut-off to saturation
Select the correct answer using the codes given below

In a sinusoidal oscillator, sustained oscillations will be produced only if the loop gain (at the oscillation frequency) is

The Class-B push-pull amplifier is an efficient two –transistor circuit, in which the two transistors operate in the following way:

PAC stands for______.

For normal operation of a transistor

Consider the following statements regarding linear power supply:
1. It requires low frequency transformer.
2. It requires high frequency transformer.
3. The transistor works in active region.
Which of the above statements is/are correct?

A full wave rectifier connected to the output terminals of the mains transformer produces an RMS voltage of 18 V across the secondary. The no-load voltage across the secondary of the transformer is

MICR stands for______.

In an Op-Amp, if the feedback voltage is reduced by connecting a voltage divider at the output, which of the following will happen?
1. Input impedance increases
2. Output impedance increases
3. Overall gain increases
Which of the above statements is/are correct?

The transient response rise time (unity gain) of an Op-Amp is 0.05s.The small signal bandwidth is

Consider the following statements:
The output of a linear circuit, driven with a sine wave at a frequency f, is itself a sine wave
1. at the same frequency
2. with chance of changed amplitude
3. with chances of changed amplitude and phase
Which of the above statements is/are correct? 

Consider the following statements:
The main contribution to photo conduction is by
1. the generation of electron and hole pair by a photon
2. a donor electron jumping into the conduction band because of a photon’s energy
3. a valence electron jumping into an acceptor state because of a photon’s energy Which of the above statements is/are correct? 

Thermal runaway is not possible in FET because as the temperature of the FET increase

For the same network, with 6 V DC connected at port A, 1 Ω connected at port B draws 7/3 A. if 8 V DC is connected to port A, the open circuit voltage at port B is

A signal may have frequency components which lie in the range of 0.001 Hz to 10 Hz. Which one of the following types of couplings should be chosen in a multistage amplifier designed to amplify the signal? 

If an input impedance of op-amp is finite, then which one of the following statements related to virtual ground is correct ? 

Hysteresis is desirable in a Schmitt-trigger because 

In a photoconductive cell the resistance, of the semiconductor material varies with intensity of incident light. 

In graded index multimode optical fiber the refractive index of the core is

Consider the following factors:
1. Number of turns of the coil
2. Length of the coil
3. Area of cross-section of the coil
4. Permeability of the core
On which of the above factors does inductance, depend?

At temperature of 298 Kelvin, Silicon is not suitable for most-electronic applications, due to small amount of conductivity. This can be altered by

By doping Germanium with Gallium, the types of semi-conductors formed are
1. N type
2. P type
3. Intrinsic
4. Extrinsic

An n-type of silicon can be formed by adding impurity of:
1. Phosphorous
2. Arsenic
3. Boron
4. Aluminum 
Which of the above are correct ?

According to Einstein’s relationship for a semiconductor, the ratio of diffusion constant to the mobility of the charge carriers is

Swept-out voltage in PIN diode happens when PIN diode is

The number of holes in an N-type silicon with intrinsic value 1.5 × 10¹⁰/cm³ and doping concentration of 10¹⁷/cm³, by using mass-action law is

A tunnel-diode is best suited for

Small recovery time of a diode is most significant for

In JFET, when operated above the pinch-off voltage, the

Thermal runaway is not possible in FET because, as the temperature of FET increases

Consider the following statements regarding an N-P-N Bipolar Junction Transistor:
1. Emitter diode is forward biased and collector diode is reverse biased
2. Emitter has many free electrons
3. Free electrons are injected into base and pass through collector
4. Depletion layers around junction J1 and J2 of BJT are widened 
    Which of the above statements are correct?

A freewheeling diode T phase controlled rectifier

The zeners incorporated within the encapsulations of some MOSFETs are meant for

When UJT is used for triggering an SCR, the wave-shape of the signal obtained from UJT circuit is

Darlington pairs are frequently used in linear ICs because, they

In a MOS capacitance fabricate on a P-type semiconductor, strong inversion occurs, when potential is

A CMOS amplifier when compared to an N channel MOSFET has the advantage of

Consider the following statements regardingoptocouplers:
1. Optocouplers are LEDs driving photodiodes in a single package to provide electrical isolation between input and output
2. Optocouplers is LED driving a phototransistor in a single package that replaces pulse transformers working at input zero crossing
3. Optocouplers are used as temporary non fixed joints between optical fibre terminations 
  Which of the above statements are correct?

Which of the following does not cause permanent damage to an SCR ?

The basic structure of an avalanche photodiode is